QSC GX3 POWER AMP 2X425W 4ohm – 2X300W 8ohm

Power levels matched to the most popular speakers
Optimized for maximum real-world headroom into 4 ohm and 8 ohm speaker systems
Inputs: XLR, 1/4″ TRS and phono input connectors for compatibility with any source
Outputs: Speakon combo accepts, 1/4″ (TS) plugs or Speakon 2-pole and 4-pole plugs (connects 2 poles only). Binding posts support all other speaker wiring systems.
Minimum depth chassis (10.1″ / 257 mm) fits in compact, inexpensive effects racks
Lightweight – less than 30 lbs.
Detented gain controls for precise setting and matching of sensitivity
GuardRail automatically protects the amplifier and loudspeakers from damage due to temperature rise or overdrive without shutting down the show
Front panel LEDs monitor power, signal and clipping
Subwoofer/Satellite crossover built-in
Power at 4 ohms/1kHz (both channels driven): 425W
Distortion (typical): 20Hz-20kHz, 1dB below rated power
Dynamic headroom (4 ohms): 2dB
Input impedance (ohms): reater than 20k (balanced)
Maximum input level: +24 dB (16 Vrms)
Input connectors (each channel):
3-pin XLR and 1/4″ TRS, balanced, parallel
Phono, unbalanced
Output connectors (each channel)
Speakon, 1/4″, binding posts
Amplifier and load protection:
Short circuit; open circuit; thermal; RF protection; load protected against DC faults
Front-panel controls and indicators: Gain controls, 21 detents; red clip LEDs, proportional, 0.1% THD threshold; green signal LEDs, threshold -35dB; blue power LED, AC on
Rear panel controls: Full range/crossover switch
100Hz, 3rd order LP (sub), 2nd order HP (top)
Dimensions” Height: 3.5″/2RU;
width: 19″; depth: 10.1″
Net weight: 27 lbs.